Standard Features of the AvantGuard 4System ComponentsOne prewired 24-pin connector One Extended Range Receiver One prewired 12-pin connector One LED
Sec on dary Ig ni tion or Heater/AC WireMore and more vehicles are being manufactured with two ignition or two heater/AC wires in order to split up t
Fac tory Theft De ter rent By passThe wires noted be low are to dis arm a ve hi cle’s fac tory alarm sys tem to per mit re mote start ing.For more in
Engine Bay ConnectionsRPM MonitoringThis is required for both RPM-activated automatic door locking, remote engine starting and BlackJax Anti-Carjacki
MANDATORY RPM PROGRAMMINGNote: This MAN DA TORY pro gram ming step must be com pleted for the AvantGuard 4 to op er ate prop erly.1. Drive the vehicle
Remote Control OperationThe AvantGuard 4 comes with two ergonomically designed remote controls: a 16-channel master remote and a 4-channel secondary“
Sensor AdjustmentDigital/Tilt Motion SensorThe Digital Tilt Motion Sensor is completely self-adjusting. No sensitivity settings or adjustments are ev
FACT—False Alarm Control and TestThe system microprocessor automatically checks for another activated sensor or trigger before sound ing the siren a s
Programmable FeaturesAvantGuard 4 comes from the factory with its features preprogrammed as noted in bold letters in the following tables. Some featu
nNOTE 1:o Press button 1 on the master remote, you will hear one chirp. Press button 1 again , you will hear two chirps. o Auto Programming is for m
nNOTE 1: Once this feature is selected, one chirp is provided to indicate that the timer has started. You can set this anywherefrom one second to 4.25
AvantGuard 4 Control Unit: Wiring Description for the 12-Pin Pigtail ConnectorPin Color Con nects to1 Red/White Battery positive (30-amp fuse) headlig
LED flashes Trig ger/sen sor in di ca tion1 flash Digital Dual-Zone Proximity Sensor2 flashes Optional OmniSensor3 flashes Digital Tilt/Motion Sensor4
feature has been programmed using the chart on page 20. If the windows still do not roll up upon a rming, refer to the Window RollUp section of this
Step 10. Test the door trig ger cir cuit.Rearm the sys tem. Wait at least 10 seconds (if the vehicle has delayed or dimming courtesy lights, be sure
Step 16. Test the Black Jax anti- carjacking fea ture.Refer to the System Check section in the BlackJax 4 section of this binder.Step 17.Test the Dig
Test 5: Leave the engine running. It should turn itself off after 30 minutes.If the IntelliStart 4 remote engine starter does not pass any of the abo
Avant Guard 4/699 3
AvantGuard 4 Control Unit: Wir ing De scrip tion for the 24- Pin ConnectorPin Color Con nects to2 Red/Black Optional OmniSensor output (+5v)3 White/Bl
Avant Guard 4/699 5
IntelliStart 4 Control Unit: Wir ing Description for the 12- Pin ConnectorPin Color Con nects to1 Black/Green Ground for automatic transmission mode2
Avant Guard 4/699 7
Passenger Compartment ConnectionsControl Unit and Extended Range ReceiverThe AvantGuard 4 con trol unit must be in stalled in side the ve hi cle. Un d
Parking LightsSee the Door Trigger & Parking Lights sections in this binder.NightVision Light Sensor1. Mount the Light Sensor in a discreet locati
Comments to this Manuals