Clifford AVANTGUARD 5 Owner's Manual download pdf (Page 16)

FACT—False Alarm Control and Test

The system microprocessor automatically checks for another activated sensor or trigger before sound ing the siren a second time, thus

preventing any further false alarms. If you wish to test FACT, simply:

1. Arm the sys tem with the re mote con trol.

2. Wait 10 seconds after the interior light turns off, then trigger the Proximity Sensor to activate t he siren.

3.Do not disarm the system, let the siren complete its cycle.

4.Trigger the sensor again. The alarm should be silent.

5. Unlock and open a door. The alarm should sound immediately. You may now disarm.

Eight-Event TotalRecall

The system’s nonvolatile memory records the identity of the last eight activated or malfunctioning triggers and sensors:

1. With the ignition OFF, press and hold the blank side of the PlainView 2 Switch.

2. Press remote control button 1 to “arm,” and then again to “disarm,” and then release the button.

3. The LED will flash 1–10 times, pause, then flash 1–10 times, etc. Write down the number of flashes in each cycle.

4.Refer to the following chart. The first number you wrote down was the most recently activated trigg er or sensor. The next number

is the second most recent, and so on up to as many as the last eight activations.

Num ber of LED flashes be tween pauses Trig ger/sen sor in di ca tion

1 flash Digital Dual-Zone Proximity Sensor 4

2 flashes Optional OmniSensor

3 flashes Digital Tilt/Motion Sensor

4 flashes Door Trigger

5 flashes Trunk Trigger

6 flashes Hood Trigger

7 flashes

An attempt was made to turn on the

ignition or start the engine while the system was armed

8 flashes

More than three consecutive incorrect

valet codes were entered while the system was in BlackJax mode

9 flashes BlackJax Activation

10 flashes System Power Interruption

5.If a sensor is often activated, decrease that sensor’s sensitivity (or reposition the sensor, if ne cessary). If a certain trigger is often

activated, check pin switch operation, verify that the pin switch is not exposed to moisture and ch eck the trigger wire for possible

shorting.

16 Avant Guard 4/699

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

No comments

Clifford AVANTGUARD 5 Owner's Manual Page 16